Rockler Router Bit Cleaning and Maintenance Kit

Considering how much wood your router bits go through, it's not surprising that they get caked with residue after a while. Keep them running like new with our handy router bit cleaning kit. The kit consists of a cleaning reservoir with on-board storage for an included folding brass brush, a ''bit grip'' with collets for safely holding your bits while cleaning, and a dual-grit diamond hone for putting a fresh edge on the cutters. The lid features circular holders that are stepped to accept 1/4'', 8mm and 1/2'' shanks. Just plug your bits into the holders and once the lid is installed, it suspends your bits upside down in the cleaning solution (#77319, sold separately) without allowing the cutters to clank against each other.

Router Bit Cleaning and Maintenance Kit Details:

• Complete, all-in-one cleaning and maintenance kit for router bits makes it easy to keep your bits clean and sharp for optimal performance
• ''Bit grip'' with 1/4'', 1/2'' and 8mm collets helps you safely hold bits while removing bearings, cleaning or honing edges
• Both lid and bit grip collets accept 1/4'', 1/2'' and 8mm router bit shanks
• Bit grip can be held by hand or in a vise, as well as clicked onto base for bearing maintenance or honing
• Reservoir on base holds up to 10.5 oz. of cleaning fluid (#77319 sold separately)
• Lid for reservoir tightens with a fraction of a turn. On one side, the lid has a shallow dish with rounded corners at the bottom for easy retrieval of small parts like bearings and screws; on the flip side are five circular shank holders, stepped to accept bits with any shank diameter, allowing them to be suspended in cleaning fluid
• Translucent reservoir features viewing windows for assessing the bits inside, plus an O-ring gasket for a tight seal
• Reservoir can accommodate bits sized up to 3-1/4'' in diameter
• Folding brass wire cleaning brush works great for loosening stuck-on pitch
• Two-sided diamond hone features 300 grit on one side and 600 on the other and can be rotated in handle so both halves of hone can be used
• Both folding brush and diamond hone lock into underside of base for convenient storage and easy retrieval
• Includes three hex wrenches—5/64'', 3/32'' and 1/8''—for removing most bearings; all wrenches store in dedicated slots on bit grip
• A hang hole is provided for storage (drain reservoir first)

Note: We recommend using Pitch and Resin Remover (#77319, sold separately) to clean your router bits and bearings.